Desert Mode Mojave 6S
Desert Mode Mojave 6S
Teilen
The kit includes following components
Front LED Extremely bright front LEDs that can be easily mounted underneath the roof at existing holes of the cage.
Rear LED Two red rear LEDs that can be easily attached to existing holes on the cage.
Power Up Mojave The Power Up module allows for easy power supply of the LEDs via the receiver.
Note The LEDs from the Wald Light Kit can only be operated with the Power Up module.
Installation instructions
1. Mount the front LED below the roof by screwing in the four included M3 screws from the top through the cage into the holes of the front LED.
2. Attach the two rear lights to the body using 4 of the included washers and nuts.
3. Connect the power-up module to the LED lights and secure it to a suitable location inside the body, using cable ties or tape.
4. Plug the included cable into the receiver. This will connect to the power-up module when the body is assembled. When the body is removed, the connection will also be disconnected at this point.
5. Secure the cables for the LED lights, using cable ties, so that they are protected and do not come into contact with sharp edges. Make sure that the cables are not under tension and have enough slack.