Bash & Blast X-Maxx

The kit includes the following components

Front LEDs Extremely bright front LEDs that are easily installed on the front bumper.

Rear LED Extremely bright rear LED that is easily attached to the screw of the wheelie bar.

Power Up Easy power supply of the LEDs via the receiver.

Attention The LED lights of the Wald Light Kit can only be operated with the Power Up module.

1. Attach the front LED to the front bumper using the included M3 screws.

2. Remove the two M4 screws that secure the wheely bar below the rear bumper. Mount the tail light here using the included M4 screws.

3. Connect the Power Up module to the receiver and secure it in a suitable location, such as with cable ties or tape.

4. Insert the LED cables into the Power Up module.

5. Secure the LED cables, such as with cable ties, so that they are protected and do not come into contact with sharp edges. Make sure the cables are not under tension, but have enough slack. In particular, the front bumper can deform greatly!